So how did the bending of the tank ceremony go ??? Did you chicken out on bending it down ???
So how did the bending of the tank ceremony go ??? Did you chicken out on bending it down ???
Aluminum .120 14' X 76" hull
Teledyne 4a084-4 engine
Circle S 1.69:1 reduction
67" Whirlwind "Razor X" prop
I did.
I'll make room for it the way it is.
I'd be scared too......Something has to give and with my luck usually it doesn't go the way I thought it should... With all the seams of a steel tank it really wouldn't take much to split a corner or side...I think you made the right choice IMO...
Aluminum .120 14' X 76" hull
Teledyne 4a084-4 engine
Circle S 1.69:1 reduction
67" Whirlwind "Razor X" prop
Ok, this is how I do it but I'm not sure it will transfer to your hull. With your hull on the ground put a piece of pvc pipe in the hull and see where it balances. It would be about four feet from the back of the hull. You should be able to get your tank location close like this. I ran my boat to see where it rode on plane then put the pipe under that point and tried to get the balance as close to that point that I could.
Depending on the hull length and construction you may not get things where they need to be but closer is better. This is another reason I like a little longer hull.
Please check out our YouTube channel and subscribe! Our YouTube Channel helps fund the site. Check it out at https://www.youtube.com/channel/UCTv...FrJP7yQVFVZnyA
Papee how many more tricks do you have up your sleeve. that is a simple & quick method to find the balance point.
That's what I was going to use too.
The hull is 11'2" from the front of "Grass" racks to back.
So it should balance at around 3 feet from the back ???
Bookmarks