Got my fuel tank today. I think it will work out very well.
It has fuel take outs on top as well as a tube to vent the tank.
I'm going to adapt My Snowmobile filler cap and fuel gauge,
just a float and indicator, to fit in the top where the Car fuel pump would be.
I wish the front portion was an inch thinner.
There are no baffles in that part of the tank.
Think I could slowly crush it down an inch or two?
I was thinking a 3/4" piece of plywood and lower the truck on to it

To make a slight "Taper" to the front 4" of the tank...