bgmcl60 Build

[bgmcl60]

woops: i installed the copper line on the wrong place at the back of engine. i've got it hooked to the in and it should be hooked to out. after running 5 min its cold as ice. the out line is warm going to the oil cooler. need to change both fittings location not to screw of the flow to filter. well at least i thought i did. just checked it again and copper tubing is connected to out at the oil pump where oil should be pumped out by oil pump. now after running it a little longer the tubing is starting to get warm but not hot. the intake is cold and may take a while to heat up.