Results 1 to 1 of 1

Thread: Anyone using a hovercraft fan/duct setup for thrust?

  1. #1
    Level 1 Supporter
    Join Date
    Jul 2016
    Location
    Lincoln, Nebraska
    Posts
    4

    Anyone using a hovercraft fan/duct setup for thrust?

    My first airboat was a 4x8 plywood hull - pictured in my profile pic. I went through about half a dozen engine/prop setups including a rotary snowmobile engine and even a Berkeley jet drive :/ - finally settling on a fan/duct thrust unit from a hovercraft that just didn't work on a sandy (messy) Platte river. I haven't had it in the water for quite a few years now but hope to have it or a newer similar version on the water this summer. I haven't heard about anyone using this type setup - but mine was running pretty good back in the day. I like the no cage (less weight) - small diameter fan (24") - low overall height (42" from bottom of hull to top of intake duct - after lowering engine/fan module and incorporating 2 small rudders instead of the 1 larger - the entire placement of which is now different from that shown in profile pic) - and finally the less/different type of noise produced - but am aware it does not produce as much thrust as a similar prop/engine setup. Performance was all I needed on my 4x8 boat - and for me anyway the aforementioned pros are more important than the loss/difference in thrust. I would be interested in hearing if anyone here has had any experience running similar units or just wants to throw out some thoughts on the subject - - -
    Last edited by Gene Sengstake; 04-25-2017 at 12:50 PM.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •