I bought a used KCP v-twin 20hp. The engine ran fine but had a very small oil leak behind the starter. The silicon between the cases had pushed out. I went to NAPA and got a tube of the best sealant they sell. Fixed the leak,put the case back together.
I was checking the choke, throttle, and govenor linkage to plan my control setup.
I noticed the govenor doesn't move now. I didn't do anything to it.
Just removed the case cleaned it and steamed cleaned the inside of the engine.
put it together. I haven't even put oil in it yet. Will I have to spin the engine to make the Gov move? I don't see how anything could be broke.
Thanks
zion
Bookmarks