Thanks Corky I have her tore down right now ,putting wire on cage ,quick slick on bottom,Painting cage.
We will start putting her back together and start building Darrells boat in next few days....
Type: Posts; User: txriverrat
Thanks Corky I have her tore down right now ,putting wire on cage ,quick slick on bottom,Painting cage.
We will start putting her back together and start building Darrells boat in next few days....
cooling off time to finish this little boat.
Ron
I have decided to not use my arrw prop redrive.
It is new in box paid 740.00 for it
will sell for 600.00
Ron
What kind of ultra prop and how much?
Thanks Ron
I use to do a lot of aluminium work in my fab shop , a little trick on the tips.
Run a flat file over the end ,like pappee said , pull out the wire . If it leaves a ring or a piece of wire in the...
We have some serious wind here in TX ,50 mph hour head wind and 65 miles an hr vehicle speed gives you 115 mile an hour wind .
My big boat was a 8 +18 with a 575 hp caddy on the back with a...
For me rudders are not a problem , but I do tie my prop. A couple of times running down the highway at 65 and running into a strong headwind I would look back in the mirrors and the pop would be...
I hope the best for you and keep on keeping on .
We need you here.
Ron
Sorry for your loss.
Ron
Here wishing a enjoyable and safe holidays to the folks here.
Ron
Just keep on doing what you have been doing ,I know I sure enjoy the detailed reports.
Ron
Corky
All my life I ran a machine and steel fab shop. Your workmanship empresses me ,great job.
Ron
I am not Kirk
But on my hover craft I used a 2 amp charger and 035 stainless welding wire, Just dont get in a hurry.
Ron
Harbor freight, Lowes, Home Depot all have engines in that class.
Ron
Any progress on this ?
Ron
How do you fix your carp?
Ron
Kirk
I dont know how to ask this without sounding like I am criticizing, but I am not I promise.
On the quick slick I noticed it has a rough or pebbley finish ,is there a reason for that ?...
on the flounder rig I have 16 inch side ,that is just a little low . with a 60 inch wide sheet if you use 20 inches for sides and transom it works out with no scrap.
Ron
Just a little advice from a old time pipe welder . Never start and stop your welds inside and out in the same place. If you stagger them your chances of a leak are just about zero.
Ron
Papee
I hope you do this. I have a Caviler that was my moms , 18 thousand miles on it
It is a 97 so I am not sure if it is the same type motor.
My bowfishing rig is a 7ft wide by 11 ft long ...
Wonder how much difference there is in a spinout on water and ice?
Ron
Kirk
Glad your ok.
I bet that was a rush when the boat just kept sliding.
Ron
so far I have had pretty good luck, 3 turkeys ,a doe and a big 10 point.
Backstrap gravy and hot biscuits is hard to beat.
Ron
I got side tracked with bow season want start it till after the first of the year.
I do have redrive,prop,alum sheets and motor sitting here.
Ron
I am using the ultra 5 blade on a generac 40 hp
Ron