what a great loss super nice guy rip
Type: Posts; User: fresh water hunter
what a great loss super nice guy rip
i am selling my 4a084 bearing were checked good compression unsure on hrs. has new vw carb custom intake, new extra pistons and rods, new jugs, new mag, and extra mag kits, oil cooler. oil temp gauge...
your hull would be fine as far as the exhaust you will have to jet the carb for a tuned pipe i am running a 70 hp yamaha piped motor 2.75 belt reduction and spin a 68 in three blade warp drive at 8...
j bird belt drives are 10 hp per belt dr. peck in the builds is using one of the rx1 yamaha engine on here the do make an adapter so you can use a c gearbox
yes just the red part
i am looking for the front engine mount that mounts to the block for a 4a084 thanks
that sucks you need a clockwise rotation prop thats for right hand rotation
well if it was an ultra prop you just flip the blocks over
so you are running on the end were the stater and pull start pulley are located ?
i built my front mount out of aluminum but set it up to be bolted on both sides my stand is made with 2 angle iron at top and 3/4 by 18 ga. square tube with bracing my question is are the circle s...
I have no mounts on my engine so i have to fab them up also my front mount is flush with top of oil pan. on the circle s drive how far from block out to bolt center and is the bottom of mount flush...
ok thanks now i just need crankshaft center to prop center still waiting on my drive to be built
check out blankbiplane on u tube he has a nice chaindrive set up and has an email on his video for asking questions
Does any one happen to have any measurements on the circle s drive shaft to shaft center spacing mount bolt center from block out and center to center mounting holes thanks
what one are talking about snowmobile or motorcycle?
ya i thought about that and i got the rivets thanks corky
here are some more pics
got a little more done than had to head to florida again best friend is dyeing damn cancer 52 yr old
weld the seam then you cut your sides and transom to the height you want and the front rake and weld it all together you can put a bend in the side to increase side strength if using thinner aluminum
it sure does. ran out of wire burnt my last tip off to the weld shop for you guys that weld aluminum i have been using maxel 4943 wire that suff is great flows like 4043 but but way stronger i wont...
it is 12 ft long and 5 ft bottom with 20 in gunnels 76 wide at top of transom all .125th. aluminum
that was day one here is day two lots of welding
Well Its been a long time coming but got some material and here we go i just want to thank every one for there build post's;thumb; it has helped me
check out airboatpros chucks ecotec builds he did a 300 hp all aluminum 4 cylinder turbo engine on a little boat sweet amount of blades depend on length and hp tq you have to turn them plus pitch...
do a compression test it will tell you a lot on the engine leaking seals are a 2 stroke enemy how big is the prop i am running a 68 in. on my 70 hp yamaha and yes mix your oil we raced them 250 miles...